PPC Products

Products / Cement / About

About PPC Cement

Cevronseperator Cement

Product Overview -Banners -Zimbabwe

 

FACILITIES
 

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

 
Cement Shevron Divider

 

Quarrying and crushing

About Quarryand Crusingimg The primary raw material for cement manufacture is calcium carbonate or limestone. This is obtained from the quarry where, after the removal of overburden, the rock is blasted, loaded into trucks and transported to the crusher. A multistage crushing process reduces the rock to stone less than 25 mm in diameter. Most modern cement factories are located close to a source of limestone as about 1.5 tons of limestone are needed to produce one ton of cement.

 

Blending and storage

About Blending The crushed rock is stored in stockpiles where, by a carefully controlled process of stacking and reclaiming across the stockpile, blending takes place and a uniform quality of raw material is achieved. Systematic sampling and laboratory testing monitor this process. The other raw materials, normally shale, iron ore and sand, are also stored in stockpiles.

 

Raw milling and homogenisation

Aboutrawmilling Carefully measured quantities of the various raw materials are fed, via raw mill feed silos, to mills where steel balls grind the material to a fine powder called raw meal. Homogenising silos are used to store the meal where it is mixed thoroughly to ensure that the kiln feed is uniform, a prerequisite for the efficient functioning of the kiln and for good quality clinker.

 

Burning

About Burning The most critical step in the manufacturing process, takes place in the huge rotary kilns. Raw meal is fed into one end of the kiln, either directly or via a preheater system, and pulverised coal is burnt at the other end. The raw meal slowly cascades down the inclined kiln towards the heat and reaches a temperature of about 1 450 °C in the burning zone where a process called clinkering occurs. The nodules of clinker drop into coolers and are taken away by conveyors to the clinker storage silos. The gas leaving the kiln is cleaned by electrostatic precipitators prior to discharge into the atmosphere.

 

Cement milling

About Milling The cement mills use steel balls of various sizes to grind the clinker, along with a small quantity of gypsum to a fine powder which is then called cement. Without gypsum, cement would flash set when water is added and gypsum is therefore required to control setting times. The finished cement is stored in silos where further blending ensures consistency.

 

Quality assurance

Extensive sampling and testing during the manufacturing process ensures the consistency and quality of the end product. Testing takes place at the stages of the manufacturing process indicated by the symbol.

 

Cement despatched

Aboutdespatch Cement is despatch either in bulk or packed in 50 kg bags and distributed from the factory in rail trucks or road vehicles. The 50 kg bags are either packed directly onto trucks or can be palletised. The pallets can be covered by a layer of plastic to offer further protection from the elements. Various types of cement are sold, and more information on these can be found in the Products area of the website.

 

 

Buildersapp Banner

 

 

 Cement Calendar Heading

<April 2018>
SunMonTueWedThuFriSat
25262728293031
1234567
891011121314
15161718192021
22232425262728
293012345